Zebra Gx430T Now In Dump Mac OSX Remove Your
When successful, you will receive a printout that says "Out of dump."On Windows and Mac OSX remove your printer and re-add it with an alternate driver. You may have also received a printout from your printer that looks like this:To remove the printer from "Dump" mode, simply click the feed button on the printer once. A single blank label will be fed out.You are receiving an "unable to detect language" errorThis may be happening because the printer is in "dump" mode. Press the green feed button once. See below for more details on important functions.The printer needs to detect the label size before it can print any labels. Each of these groups of flashes indicate a different function that the printer can perform.
Once you find the level you would like, you can press the feed button. It will then feed out a label with a test of the darkness and pause for approximately 3 seconds before going to the next darkness. This will print out a lot of labels.When the process is complete the printer will feed out a single blank label.If your labels are suddenly printing much lighter than expected, the default print darkness of your printer may have been changed.You can recalibrate the default darkness to your preferred setting by pressing and holding the green button until it blinks 6 times. In order to re-calibrate the printer follow these steps:Insert the roll of labels you plan to print from.Wait for the group of two flashes, then release the feed button.If that doesn't work, try a full calibration:Insert the roll of labels you plan to print fromWait for the group of seven flashes, then release the feed button.A re-calibration process will take place. Included on one of these labels will be the printer's IP address.We have discovered that at times, especially when switching to new label types or sizes, the printer must be re-calibrated in order to properly detect the size and position of the labels. These labels contain diagnostic information about the printer.
0 kommentar(er)
